Limiting Munis Access For Users

Need to lock out users from Munis so that we can install updates or complete year end processes

• Limited Access Munis
• Limited Access Mode
• Year End Close 
• Lock out Munis Users
• How to set limited access in Munis
• How to set limited access in EERP
• EERP limited access
• Locking Down Munis

When Munis access is set to Limited, only the specified users or roles will be able to log into Munis.

To limit Munis access for users in an environment please do the following:

1. Sign into the desired Munis environment with a user with System Administration access
2. Navigate to System Administration > General Administration > System Settings
3. Click on Munis Access (has a green dot when set to full)
4. Click on Limited
5. Under Role Exceptions, enter in roles as desired
6. Under User Exceptions, make sure the following are listed
   1. munis (or equivalent)
   2. wsuser
   3. schedusr
   4. XXXXsupp (if applicable)
   5. XXXXweb (if applicable)
   6. Users that need access to perform tasks
   7. System administrator(s)
7. Click Accept 
8. The Munis Access dot will now be red
9. To set Munis access to back to full, return to System Settings
10. Click on Munis Access
11. Click Full

• Please note: Users that already logged into the Munis environment before it was set to limited access will remain in the environment until they sign out. They will not be able to sign in again until full access is re-enabled. If you need to disconnect users from the environment, you will need to restart GAS services for that environment.
• Once you no longer need limited access in place, you will need to go back to the Munis access screen and switch it back to full access.
• Munis Support recommends notifying your site users of the environment down time. Please see: Create a HUB Announcement or Notification banner message
• To limit access from Hub : Limit access to Tyler Hub