Resolution

TouchTime 3 (Windows) Network Setup

Option 1:

DHCP - Recommended

The devices can be plugged into a DHCP enabled network to automatically obtain the network information needed to connect to the network.

Option 2:

Configuring a static IP address

Note: Plugging in a USB Keyboard and Mouse can help

Plug in the power supply and network cable to the back of the clock
1. The power button may need to be pressed to power on the device
Dismiss the Registration Prompt by inputting ALT+FN+F4 (On virtual keyboard)
Reboot the device to OS
1. On the device, click the Settings button in the top right corner
2. Enter the Admin Password
  1. Don't have a record of this password? Please contact Time & Attendance Support or log a case via the Online Support Client Portal and reference this article
3. After the password is entered, a TouchTime Emulator - Settings window will open, from here navigate to the System tab
4. From the System tab, use the drop-down box to select Reboot to OS or Reboot to Kiosk Mode
5. Select the Confirm button
Once on the desktop of the device, hold a finger on the Windows key and release (simulating a right click) and select Network Connections
Find the adapter named Ethernet.
1. Make sure that the description does not note that this is the reader of the device. It will say something along the lines of HID or ICLASS
Hold a finger on the Ethernet adapter and release (simulating a right click) and then select Properties
On the Properties tab, scroll down on the list to find Internet Protocol Version 4 (TCP/IPv4) and select that option
Select the Properties button
Type in the device's IP Address, Subnet Mask, and Gateway.
1. This is client information
Select the Use the following DNS server addresses: and enter in primary and secondary DNS
Once all settings are set, select the OK button
Navigate to the desktop
Hold the icon that is Launcher - Release and release (simulating a right click) and select Run as Administrator
1. This will boot the Emulator back up and restart the device

Browser not supported