Versions Compared

Old Version 1

changes.mady.by.user Knowledge Assistant

Saved on

compared with

New Version 2

changes.mady.by.user Knowledge Assistant

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Panel
borderColor#03396c
titleColorWhite
titleBGColor#03396c
titleDescription of Issue

In the over-short adjustment program, when Define when Define is clicked and criteria entered, then the user clicks Selectclicks Select, the message No records were found that satisfy the selection criteria appears at the bottom of the program in red text.

...

Panel
borderColor#03396c
titleColorWhite
titleBGColor#03396c
titleCause

A potential combination of two factors;

  • There are bills within the selection criteria that have outstanding interest on them
  • When define When define is clicked, if there was criteria filled in, Reset  Reset should be chosen


Panel
borderColor#03396c
titleColorWhite
titleBGColor#03396c
titleResolution
  1. Navigate to Bill Inquiry
    1. Munis > Property Revenues > Accounts Receivable > Inquiries and Reports > Bill Inquiry
  2. Search for bills within the selection criteria to confirm interest exists on bills within criteria.
  3. Navigate to Forgive Interest
    1. Munis > Property Revenues > Property Tax Billing > Northeast > Your State > Collection Processing > Forgive Interest
  4.  Click Define and enter the criteria for the bills not pulling into Over-short adjustment processing.
  5.  Click Select and confirm, in the Records box, records have been selected.
  6. Output-Post, click Save, click OK
  7. Navigate to Over-Short Adjustment Processing
    1. Munis > Property Revenues > Property Tax Billing > Northeast > Your State > Collection Processing > Over-short Adjustment Processing
  8. Click Define and enter the criteria for the bills to be over-short adjusted.
  9. Click Select and confirm, in Records box, records have been pulled in.
  10. Output-Post, click Save, click OK
    1. If records still do not pull in, verify, when clicking Define, choose Reset
    2. Repeat steps 8-10

...